|
|
 |
Model MDCSW Medium Duty Channel Slider Bed "Wide"
View
Catalog Sheet  Print
This Page
The Medium Duty Channel Slider Bed "Wide" is constructed with
channel side frames. This construction is well suited to wide belt applications.
STANDARD SPECIFICATIONS
Belting: Standard B98 PVC-120 black, covered one side. Belt is shipped laced and installed on conveyors up to 10’ long. On all
other conveyors the belt is shipped loose with lacing installed for field installation.
Belt Widths: Standard widths are 42”, 48”, 54”, 60”, 66”, and
72”. Also available from 42” to 72” in 1” increments.
Lengths: Minimum of 3 times the belt width up to 100’ in even
inch increments.
Drive: Standard D46 - end, right hand side, 8” pulley. Drive
has cast iron worm gear speed reducer with Standard M03 3/4 HP 230/460 bolt TEFC motor.
Speed: Standard 60 feet per minute standard. Also available from 3 to 150 fpm.
Bearings: Sealed pre-lubricated, cast iron flange ball bearings.
Frame: 6-1/2” x 1-1/2” x 1/8” formed steel channel with 1/8” formed
bed pan.
Drive Pulley: 8” dia. with 1-7/16” dia. shaft, crowned and
lagged. Mounted in 2 bolt flange bearings.
Take-up Pulley: 6” dia. with 1-7/16” dia. shaft, crowned and
lagged. Mounted in 2 bolt flange bearings.
Return Rollers: 2.5” dia., 11 ga. wall tubes with 11/16” hex
cold rolled steel axle, spring retained. Standard A51 bearings are grease packed.
Snubber Roller: Standard 1.9 dia. 12 ga. wall tubes with 7/16” hex cold rolled steel axle, spring retained. Standard
A23 bearings are grease packed with front and back seals. 2.5 dia. 11
ga. wall tubes with 11/16” hex cold rolled steel
axle, spring retained. Standard A55 bearings are grease packed with front and back seals. Used on conveyors with
D42 & D43 Center drive Option.
Supports: SPH style adjustable set for a Standard 36” top of
conveyor located on nominal 10’ centers. Also available from 7.5”
to 42” top of belt at no additional charge.
Guard Rail: Standard G99: No guard rail.
Finish: Standard P94: Safety Blue.
|
|
|
|
|
